Global Sentinel, Руководство по эксплуатации, Страница: 9 / 70

Global Power Technologies IMPORTANT SAFETY INSTRUCTIONS
302842 Rev0 | Sentinel Page 2 of 61
12. Do not exceed the fuel pressure stamped on the data plate without factory approval. If fuel
pressure exceeds reasonable levels, the power unit may be seriously and permanently damaged.
13. The Sentinel Thermoelectric Generator exhaust can be very hot. Do not touch any of the exhaust
components or bring exposed skin near hot exhaust gases.
14. Exhaust gases are toxic and should not be inhaled. The Sentinel Thermoelectric Generator is
strictly an outdoor appliance and should never be used indoors. Avoid inhaling exhaust gases
while working around or above the Sentinel Thermoelectric Generator.
15. The heater cartridge will become hot during normal operation. Ensure that the Sentinel
Thermoelectric Generator has been given enough time to cool, before handling the heater
cartridge.
16. The Sentinel Thermoelectric Generator must be installed on or over non-combustible floors.
17. Do not use the Sentinel Thermoelectric Generator if the catalytic pad becomes torn or damaged.
Continuous use may result in injury or death due to fire, explosion, or carbon monoxide
poisoning. The appliance must be serviced by a licensed and qualified service technician.
18. Installation of this appliance at altitudes above 2,000 ft [610 m] shall be in accordance with local
codes, or in the absence of local codes, the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or the
National Standard of Canada, Natural Gas and Propane Installation Code, CSA B149.1.
19. The Sentinel Thermoelectric Generator is FOR OUTDOOR USE ONLY.
20. The Sentinel Thermoelectric Generator and its individual shut-off valve must be disconnected
from the gas supply piping system during any pressure testing of that system at test pressures in
excess of 3.5 kPa (0.5 psi).
21. The Sentinel Thermoelectric Generator must be isolated from the gas supply piping system by
closing its individual manual shutoff valve during any pressure testing of the gas supply piping
system at test pressures equal to or less than 0.5 psi [3.5 kPa].
22. The Sentinel Thermoelectric Generator consists of some parts constructed from sheet metal.
While every effort is made to ensure that edges have been deburred when manufactured, sharp
edges may still exist. Caution must be exercised when handling and use of gloves is
recommended.
23. If a hose assembly is used to connect the Sentinel Thermoelectric Generator to the gas supply
piping system, inspect the hose assembly before each use of the Sentinel Thermoelectric
Generator. The hose assembly must be replaced prior to the appliance being put into operation if
there is evidence of excessive abrasion or wear, or if the hose is damaged. The replacement hose
assembly shall be as specified by the manufacturer. Properly locate the hose out of pathways
where people may trip over it or in areas where the hose may be subject to accidental damage.
24. When the Sentinel Thermoelectric Generator is operating, surface temperatures of the unit can
approach temperatures close to 200°C [392°F]. Avoid contact of skin and clothing with the
surfaces of the TEG to avoid burns.
25. For any customer connection, use wires rated for at least 100°C [212°F].