Global S-8500, Руководство по эксплуатации

Страница: 14 / 74

Global Power Technologies 8
S-8500
4. Opening the manual shut-off valve causes the Spark Ignition (SI) module to spark and
the pilot solenoid valve to open as indicated by LED L1 on the SI Controller module, see
Figure 2.
5. Three ignition trials are made.
6. If unsuccessful on all three attempts, the SI will go into Lockout mode. The red Lockout
light on the SI Controller board, LED L5 will turn on and the SI will be powered down.
7. To reset the SI Controller board after a Lockout, wait 10 seconds after the red light turns
on, then press the SI Controller’s on-board reset switch S1. If the pressure switch is still
closed, the SI module will turn on and another three ignition trials will be made.
8. 60 seconds after successful ignition of the pilot burner, the main burner solenoid valve is
turned on, as indicated by LED L2 on the SI Controller and the TEG will rapidly heat-up
and start to produce power.
Note: The ignition system contains a single 6 V, 5.0 Amp-hour monobloc rechargeable battery
and a battery charger. A new fully charged battery provides approximately 120 minutes of
operating time at 25 ºC. Completely discharged batteries will take approximately 20 hours of
TEG operation to regain 100% charge as long as the output load is not overloading the TEG
and the Customer Load circuit breaker is “ON”. The battery will NOT charge if the Customer
Load circuit breaker is in the “OFF” position.” The highlighted portion inside the note shall
be removed as it is not true.
Figure 2 SI Controller Interface
V2
V1
-
+
CHS
CHS
-
+
H1
H2
64228 Rev2
DETAIL
SCALE 1 : 5
L1
L2
L4
L3
L5
L6
L7
S1 FB FE
SPARK RETURN
POWER