Global BM 345, Инструкции механика

Страница: 19 / 25

19
2.10 Transporters
The machine is equipped ex works with the pyramid-toothed transporter. After
loosening the two screws, its motion towards the needle plate can be adjusted.
2.10.1 Adjusting the transporter (figure 9)
CAUTION! Injury hazard!
Switch off the machine electrically!
1. Set the stitch length to 8 mm.
2. Clamp down the transporter so that it lies parallel to the needle plate and
the lower part of the tooth protrudes beneath the bottom of the needle plate.
It must not collide with the sides of the needle plate opening amd should be
set forwards as far as possible towards the needle.
Clamp a piece of paper with 0.2 mm to the tip of the needle 2 mm in front of the
centre of the presser.
Figure 9