Instruction Manual
5
INSTALLATION
• It is recommended that 2 or more people install this unit.
• To avoid the risk of property damage and/or personal injury, mount this fountain to a flat
finished wall surface adequate to support up to 300 lbs.
• Locate and install plumbing through wall as required. Refer to Rough-In Guide (page 4)
for proper location and correct plumbing.
• Install a drainable shut-off valve (not included) if in a freezable environment.
• Installation of a trap on the water drain line may be necessary; check local plumbing codes.
WARNING:
The fountain is rated for inlet water pressure of 20-105 PSI. A pressure reducing
regulator should be used if the inlet water supply exceeds 105 PSI. Any damage caused by
reason of connecting this product to supply line pressure higher than 105 PSI will void warranty.
Flat-head anti-theft screw
M6 x 10 (qty 8)
1. REMOVE ACCESS PANEL
To gain access to the drain and water line connections, remove the access panel detailed
below using the provided torx key wrench (H1) or torx drill bit (H2) to remove all (8) M6 x 10
flat-head anti-theft screws on the underside of the drinking fountain pan:
REMOVE
Outdoor Wall Mounted Drinking Fountain
