CHAPTER 2 – INSTALLING A NEW CABINET
Upright Cabinet Installation
Standard Upright Installation
When used in the standard configuration, without a driving seat, the upright cabinet requires no additional
installation. The driving pedal components are shown in
. These components need to be removed
and reconfigured if the optional seat assembly is installed. Refer to the following section for more information.
3/4" Wood Screw
(3x) 1-3/4" Torx Security Screw
+ Lock Washer
+ Fender Washer
Brake and Gas
Pedal Connectors
Brake and Gas Pedals
Pedal Mounting Plate and Panel
Foot Panel Bracket
(4x) 2-1/4" Torx Security Screw
+ Lock Washer
+ Fender Washer
Figure 13
– Standard Upright Configuration Installation/Removal
Upright Installation with Seat Assembly
The optional seat assembly is shipped separately from the upright cabinet. Use the following procedure to
remove the standard pedal configuration, mount the pedals on the seat assembly, and connect the seat
assembly to the cabinet:
1. Turn cabinet power OFF.
2. See
on page 6. Remove the (3x) 1-3/4" Torx screws holding the back of the foot panel bracket
to the cabinet. Remove the 3/4" wood screw on the left side of the foot panel bracket.
3. Slowly pull the foot panel bracket back from the cabinet, exposing the brake and gas pedal connectors.
Unplug the pedal connectors.
4. Remove the entire foot panel bracket and pedals from the cabinet.
5. Remove the (4x) 2-1/4" Torx screws holding the pedal mounting plate to the foot panel bracket.
6. Remove the (8x) Torx machine screws holding the pedals to the pedal mounting plate. Pull the pedals and
cables free from the pedal mounting plate.
7. Use the (8x) Torx machine screws to mount the pedals to the seat assembly. Thread the cables through the
hole and pull them to the front. See
Need For Speed™ GT
System Documentation
13
040-1201-01 Rev. C 5/28/2004
