CHAPTER 2 – INSTALLING A NEW CABINET
6. On the back of the driving console is a wire harnesses with two 4-pin connectors. This harness connects to
the u5.1AMP on the inside of the monitor console, as shown in the figure below. You will need to run the
audio wires through the hole just above the u5.1AMP.
– The
(R)
wire connector connects to the Rear Audio port.
– The
(C/S)
wire connector connects to the Center/Base audio port.
Figure 11
– Connecting the Driving Console Speakers
Deluxe Cabinet Driving Seat Installation
1. Follow the procedure on page 8 to install the driving seat.
2. Once all the wires are connected between the driving seat and the two consoles, power the cabinet ON.
Go into the Operator Menu and verify all the driving controls and ensure that sound is coming out from the
correct speakers by using the Player Control test and the Sound test.
Figure 12
– Bolting the Driving Console to the Monitor Console
3. When testing is complete, push the driving console onto the monitor console as shown above. Make sure
the wire harnesses will not be pinched or damaged when you push the two consoles together. Insert the
bolts on the driving console first, and make sure they connect with the rails on the inside before tightening.
If the holes in the rail do not line up with the holes in the cabinet, insert a small screwdriver in the hole of
the cabinet to slide the rails into place so the bolts will connect with the mounting holes.
The deluxe cabinet is now ready for game play.
12
GLOBAL
VR
040-1201-01 Rev. C 5/28/2004
