Physical Address: Corporate HQ
301 Meuse Argonne | Hicksville, OH 43526
800.782.6761
•
419.542.7751
•
f:
419.542.6690
Global Solutions Distribution Center/Test Kitchen
4300 E Magnolia Street | Phoenix, AZ 85034
October 13, 2020
globalsolutionsfoodequipment.com
OPERATING INSTRUCTIONS
Introduction :
1. Please read instructions before using this appliance.
2. When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock and
injury.
3. Clean machine thoroughly before and after each use following
the cleaning instructions provided below.
4.
Electrical Requirements :
Plug unit into a grounded outlet with correct voltage and
sufficient power capacity. Refer to the product label (serial
plate) on the unit for voltage and wattage requirements.
Operation :
1. Plug cord into grounded electrical outlet of the correct
voltage.
2. When properly connected, the induction cooker will
beep once and the light above the ON/OFF button will
blink, indicating power has been applied to the unit. If
the power indicator light is not illuminated and the unit
is plugged in, check the power cord connection.
3. Place suitable cookware onto the cooking surface.
The cooktop surface will not heat up if the wrong type
of cookware is used or there is no cookware on the
surface. Never place empty cookware on the cooker.
4. Set HEAT, TEMP and if desired, TIMER.
A. Press the ON/OFF button one time. The HEAT
indicator light will begin flashing.
B. Press FUNCTION. Toggle between HEAT,
TEMP and TIMER settings. The light indicator
next to each function will illuminate to indicate
which function is ready to be set.
C. Set HEAT. (Heat is the amount of power in watts
applied to the cookware.) Use the UP or DOWN
buttons to set HEAT, the default power of heating
is 1200W. Adjust the power from 500W
–
1800W.
D. Set TEMP. Use the UP or DOWN buttons to set
TEMP, the default temperature is 200°F. Adjust
the temperature from 140°F
– 460°F.
Portable Countertop
Induction Range,
Heavy-Duty
Model Series:
GS1680
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed, including the following:
1. Warning! All power must be disconnected at power source
before any service procedure is performed.
2. This appliance is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials, such
as drapes and other furnishings, away from appliance.
3. Extreme caution is necessary when any appliance is used by
or near children and whenever the appliance is left unattended.
4. Always unplug appliance when not in use and before cleaning,
adjusting, or maintaining this machine. To disconnect appliance,
turn controls off and remove plug from power source.
5. Do not operate any appliance with a damaged or altered cord
or plug, after the appliance malfunctions, has been dropped, or
damaged. Return appliance to an authorized service facility for
examination, electrical or mechanical adjustment, or repair.
6. Do not use outdoors. This appliance is not intended for use in
wet or moist locations. Never locate appliance where it may fall
into water.
7. Connect to properly grounded outlets only. Avoid the use of
extension cords. Do not run cord under carpeting, runners, or the
like. Arrange cord away from traffic area and where it will not be
tripped over.
8. To reduce the risk of fire, it is recommended that the unit is
placed on a non-combustible surface.
9. This appliance has electrical parts. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
10. Do not heat an empty pot.
11. Dn not place metallic objects on the cooking surface.
12. Maintain a minimum of 1” space around the cooking unit.
13. Do not block air intake or exhaust vent.
14. Do not touch the cooking surface immediately after removing
a pan; it will still be hot.
15. Do not place cooking unit close to objects that are affected by
magnets.
