Global Light & Power LCC ZIYA 11, Руководство пользователя

Страница: 3 / 6

www.globallightllc.com
info@globallightllc.com Fax: +971 4 341 10 90 Tel: +971 4 340 44 58
INSTALLATION GUIDE

Step 3: ( A) Connect the fixture input cable to
the 24V DC supplied wires using minimum
2.5mm cable.
(B) Solder the connections or use terminal blocks
(C) Wrap the connections with 3M waterproof tape
& electrical tape.
(D) Place all the connections inside sleeve.

Step 4: Fix the light fixture to the sleeve by provided
screws.
Step 4
Step 3
Find the location where the Recessed up light has to be installed. Install suitable wiring from the Power supply
(24V DC) to the light fixture. Do not exceed 30 meter distance between power supply and light fixture. Keep the
Power supply (24V DC) inside the junction box or Mount it on the wall in a DB box.

Step 1: Dig the mounting hole 20cm or much deeper before installing the Sleeve.

Step 2: Install the sleeve in the ground. Depending on type of tile thickness, raise the recessed sleeve by
1 - 2cm above the surface.
#Note: The lighting fixture should be installed only after the completion of all mechanical and civil works at site.
Step 2 Step 1
PWM WIRING CONNECTION FOR WIRELESS CONTROL

Step 1: Install PWM Controller in the control room or inside a DB box, in proximity of the remote in use.

Step 2: Connect the input of PWM Controller to 24V DC supplied.

Step 3: Run the signal and power output wires from PWM Controller to the light fixture and connect the wires.
# up to maximum power supply/Controller rated power
RGB - Diagram
Single Color - Diagram
# up to maximum power supply rated power