Page | 6
ROTATIONAL SERIES POOL LIFT OPERATING
INSTRUCTIONS
Prior to using the Rotational Series Pool Lift, perform a test run of the lift empty. Once
that is completed and the lift is back to original position, make sure that the arm lifts
are in the up position and the seatbelt is unbuckled, once acknowledged you are ready!
Once you are in the seat, buckle the seatbelt (make sure it is snug) and lower the arm
rails. Before you attempt to operate the lift, make sure the pathway is clear from any
obstacles.
Once you have the 4 button easy controls in your hand, press the Left or Right arrow
that specifies which direction you want the lift to move in, once over the water press
the down arrow to lower the lift into the pool, keep in mind you don’t have to go to the
bottom of the cycle, you can stop the lift whenever you deem comfortable to exit the
lift. However when exiting the pool while on the lift, you should complete the cycle back
to the top to have a completely safe exit from the pool.
Once submerged into the pool, unbuckle the seatbelt and raise the armrest and slide off
of the seat. Once you are done with your pool activity, make sure the seat is lowered
sufficiently to allow you too easily slide back into the chair. Once you are seated, buckle
the seatbelt and make sure that it is snug, lower the armrest.
Next, to raise the lift chair out of the pool, make sure you press the button/arrow that
represents up on the control. Apply continuous pressure until the lift comes to a
complete stop at the end of the complete up cycle and then press the left or right arrow
to return to the pool deck. You now can unbuckle the seatbelt and raise the arm rest
and exit the unit. Staff will turn the key on the hand control or front of the control
panel to relock the lift when the pool is not in operation.
Maintenance
