Fixed Anchor
Legend Series L-325
Position the lift in the location to be installed.
Locate the 4 pre-drilled holes on the base of the lift.
Now mark the concrete so you will know where to drill.
Remove the lift and set aside.
You will need a 7/8” rock carbide drilling bit.
•
Make sure you have accurately marked the holes locations to be drilled. After
drilling your holes it must be 2 1/2” deep
•
Clean holes with pressurized air or vacuum.
•
Administer Epoxy into each hole prior to inserting the drop in anchor.
•
Drive the anchor flush with the surface of the concrete .
•
Expand the anchors with the setting tool (provided). Anchor is properly
expanded when shoulder of the setting tool is flush with the top of the
anchor.
•
Position the lift back in place and aligned with the holes.
•
Insert drop in anchor bolts and tighten.
Setting tool shown
Pre-drilled holes on the
base of the L-325
