Instruction Manual
2
Tri-Temp UV Water Dispenser
SET UP & OPERATION
Note:
Always connect to a water main that supplies
drinking water only.
Note:
Filter (model 761014) sold separately.
1. Place the dispenser upright.
2. Position the unit at least 4 inches away from the
wall on all sides (rear, left and right).
3. Turn off water supply.
4. Connect one end of the 10-ft 1/4” PE water line to
the water inlet connection of the filter head.
5. Connect the other end of the 10-ft water line to the
water supply using the 1/2” water supply adapter.
6. Connect the 3-ft 1/4” PE water line to the water
outlet connection of the filter head.
7. Connect the other end of the 3-ft water line to the
water tank.
8. Turn on water supply and check for leaks.
9. Plug power cord into outlet. Wait at least 10
minutes before operating hot and cold water taps.
9. For initial use, flush all lines clean before consum-
ing. Place a bucket under the taps, press and hold
down all water activation buttons until water flows
out. Note: Initial water flow may have sputter due to
air in the water lines; this will be eliminated once air
is purged from all water lines.
MAINTENANCE
NOTE: Before performing maintenance, unplug the
unit. Cleaning should be done every 3 months.
Parts List
General Cleaning
1. Use a vacuum to clean the condenser. Use a
clean wet cloth to remove dirt from the unit, taps and
especially the condenser.
2. Empty and clean drip tray as needed.
Water tank cleaning
1. Fill the main water tank with water.
2. Add one to two teaspoons of liquid chlorine
bleach. Let stand for five to 10 minutes.
3. Open the drain valve and drain the water using a
bucket.
4. Let the water from filters refill tank and drain a
second time.
5. Also drain the water from the spout using the hot
and cold water taps.
Note:
Upon completion of cleaning, wait at least 10
minutes after the power cord is plugged in before
turning on the hot and cold water buttons.
TROUBLESHOOTING
Problem
Solution
Water is not coming out
of the taps.
Make sure all water lines are
connected properly.
Cold water is not cold.
It takes up to one hour after setup
to dispense cold water.
Make sure the unit is plugged in
and the cold water switch is on.
Excessive use of cold water; wait
a few minutes for water to chill.
Clean the condenser.
Hot water is not hot.
It takes up to one hour after setup
to dispense hot water.
Make sure the unit is plugged in
and the hot water switch is on.
Dispenser is noisy.
Place the dispenser on a level,
flat surface.
Excessive use of hot water; wait
a few minutes for water to reheat.
SPECIFICATIONS
Voltage:
Heating Power:
Cooling Power:
Heating Capacity:
Cooling Capacity:
Refrigerant:
Climate Type:
Weight:
Dimensions:
Frequency:
110-120V
420W
100W
1.3 G/h
0.5 G/h
R134a
ST
48.5 lbs.
14.6”L x 16”W x 45”H
60Hz
Hot Water Temperature:
Cold Water Temperature:
≥ 194°F (90°C)
≤ 50°F (10°C)
No.
Name
No.
Name
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Power Indicator
Heating Indicator
UV Indicator
Cooling Indicator
Water Spouts
Night Light
Drip Tray
Door
Cooling Switch
Heating Switch
Power Cord
Drain Valve
Water Inlet
Night Switch
