As of 01/2020
Page 2 of 3
Step 4
Step 3
The three (3) base support legs are rotated for shipping purposes.
A single deck screw is pre-installed, rotate the leg 90 degrees and
align the pre-drilled holes. Secure the leg with a supplied deck screw.
Repeat for all three (3) legs.
Align at Center with
Seats 1/2" Past Edge
With the assembled support arms on a flat surface, position a LH
and RH seat with the flat edges aligned at the center point of
the middle board of the arm assembly. The back edge of the seats
should extend approximately 1/2" from the back edge of the arm
support. See Illustration. Drill a small starter hole in the support
arms at each pre-drilled hole of the seats. Attach using 3-1/2" hex
lag screws and flat washers. Repeat for remaining seats.
Step 5
Using two people, raise the arms and seats up to rest on an object
strong enough to support the assembly at the mid point approximately
12" above the mounting surface. A five gallon bucket can be used in
this step.
Base Leg
Seat Block
IMPORTANT NOTE FOR THE NEXT STEPS: DO NOT OVERTIGHTEN LAG
BOLTS. DO NOT LEAN ON TABLE TOP OR SEATS WHEN ASSEMBLING.
Insert a base leg inside an arm support with the pre-drilled
hole in arm aligned on the base leg. The seat blocks previously
attached in step 1 should rest against the outer side of the base
seat supports.
Step 6
