After use or when the tank is full, press the switch button off to stop the machine, and pull the power cord plug
from the outlet. Discharge the suction hose from suction hole, if it is necessary, also discharge the squeegee.
Move the machine to an appropriate draining location and empty dirty water using the drain hose (tilt tank if
needed). Clean thoroughly after each use.
Maintenance
Warning: Disconnect the power before any maintenance
Periodically
:
1.
Lift the motor head and check whether the filter absorbed water from excess foam. If the filter contains
water, remove and check to see if the motor head area contains water as well. If this occurs, leave unit
open until motor head is completely dry, at which point it is acceptable to reuse. If needed, allow motor
head to sit upright in a ventilated area for 24 hours to dry.
2.
Check condition of HEPA filter and replace if needed. For replacement HEPA filters (model 713169)
contact Global Industrial Customer Service at 1-800-645-2986 or visit www.globalindustrial.com.
3.
Clean tank and all accessories thoroughly with a wet cloth.
4.
Clean the float valve, make sure it can travel up and down freely and is not restricted.
5.
Clean motor head with damp cloth, DO NOT allow water to touch the motor directly.
6.
Remove the filter dust bag, empty and reattach.
Troubleshooting
PROBLEM
ANALYSIST
POSSIBLE SOLUTION
Not Working
Properly
Not connected to power
No power in the outlet
Cable damaged
Connect to power outlet
Check the plug outlet fuse
Replace the cable
No Suction
Floor nozzle, tube, hose or suction hole blocked
Motor does not start
The tank is full, but the float valve is not working
Filter blocked
Remove blockage
Press on switch
Empty tank
Remove blockage
Week Suction
Filter severely dirty
Floor nozzle, tube, hose or suction hole blocked
Clean filter
Remove blockage
Transportation & Storage
The machine must be operated, transported and stored upright.
When transporting, remove all accessories and make sure all vacuum parts are secure.
Before storing, empty and clean the tank thoroughly, wipe down all accessories and clean filters.
Place machine in a dry and dustless area with no threat of freezing temperatures.
