Assembly Instructions
Mobile Sit and Stand Workstation
5.
Put the work surface (5) over the keyboard
tray slot. Install four phillips screws M6 x 12mm
(13) through mounting holes on the keyboard tray
slot and finally into work surface using long shaft
phillips magnetic screwdriver (22) until it is firmly
attached to keyboard tray slot.
6.
Put the LCD column (1) on the end of keyboard tray slot. Install three flat head hex
screws M6 x 15mm (14) through mounting holes on the keyboard tray slot and tighten
into LCD column with a 4mm allen wrench (19) until the LCD column is firmly attached
to keyboard tray slot.
Attaching Work Surface
Attaching LCD Column
1
5
14
19
13
Extend tray when
mounting work surface.
4
7.
The CPU holder can be installed in front of or behind the fixed
column portion of the lift pole. To install, align the CPU holder
screw holes with the screw insert holes on the side of column,
then insert four round head hex screws M6 x 15mm (10) and
tighten using a 6mm allen wrench (21). The CPU holder width can
also be adjusted using the phillips screw driver.
9
21
10
