Global Industrial 641807, Руководство пользователя

Страница: 4 / 5

4
f
Corded Wet/Dry Vacuum
OPERATION INSTRUCTIONS
1. To turn vacuum on or off, use the on/off switch located at the
front of the vacuum cover. When turning vacuum on, make sure
it is properly plugged in first while it is still off. Turn switch off
before unplugging after finishing vacuuming, or when changing
accesories.
2. To connect hose to vacuum, insert end of hose into inlet and
rotate clockwise until locked. To remove, rotate counterclockwise
and then pull.
3. To connect telescoping tube to hose, insert hose handle
into tube and rotate clockwise until tight. To remove, rotate
counterclockwise and then pull.
4. To connect floor/round brush to tube, insert bottom of tube into
brush outlet and rotate clockwise until tight. To remove, rotate
counterclockwise and then pull.
5. To use the blower, turn the on/off switch off. Insert end of hose
into blowing port, located in the front of the vacuum cover, then
turn the switch on.
6. To clear blockages in hose, reduce motor speed and press hose
into spring loaded button located on top of the cover. Increase
suction as needed to remove blockage.
7. To install/replace dust bag, open transparent inlet cover. To
install dust bag, pull back spring lock on underside of inlet cover
and slide the bag opening over the inlet pipe, then release the
spring lock. To remove a used bag, pull back spring lock and slide
the bag off the inlet pipe. Throw out used dust bag, DO NOT
reuse dirty bags.
8. To access the vacuum tank, remove the vacuum cover by
opening the two side clamps and pulling the cover up and out of
the tank.
9. To replace/clean filter, remove the vacuum cover first to gain
access. Pull filter up to remove. Submerge filter in soapy water to
clean. Allow time to dry completely before reinstalling. If filter is
excessively used or damaged, replace with a new filter.
WARNING
DO NOT use vacuum to suck
or blow burning or flammable
material or otherwise hazardous
chemicals