2
LED EDGE LIT PANEL
Assembly Instructions
PREPARE PANEL FOR INSTALLATION
1. Remove two (2) screws holding access cover plate
in place and remove knockouts and install strain
relief.
2. Bend suspension tabs as shown (Fig. 2 & 3)
3. Place one end of the product on the T-bar. Hook
tabs onto "T" bars to secure. (Fig. 4 & 5)
4. After securing the product on the T-bar, secure
panel to the ceiling with aircraft cable or wires
capable of supporting 100 lbs. minimum.
5. With power turned off at the breaker or fuse box,
feed power leads through strain relief and secure.
Using the terminal block, connect power leads to
driver, blue wire (neutral), brown wire (hot) and
yellow/green (ground).
6. Re-install cover plate back on to driver housing
and secure in place with two (2) screws.
NOTE: Save these
Instructions
T-Bar
T-Bar
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Terminal
Block
Fig. 7
Fig. 8
Fig. 9
White
Yellow/Green
Neutral
(Blue)
Line
(Brown)
Green
Black
Ground
Fixture "T" Bar Clip (Tab)
Note: The suspension
tabs must hang over
the "T" Bar
