Global Industrial 293127 Скачать руководство пользователя страница 4

4

P

edestal Oscillating Fan

Usage:

Fan operation: 

Always operate the fan in the upright position 

following all instructions and recommendations listed in this 

manual.

Fan location: 

Place the fan in the area of the room that will 

provide proper fan cooling.

Fan connection: 

Plug fan directly into 120 volt A.C., 60 Hz wall 

outlet. Be sure plug fits tightly in outlet. A loose connection may 
cause overheating and damage to the plug or fan.

Note: 

To prevent overloading a circuit, do not plug the fan into a 

circuit that is servicing other electrical needs.

Speed control: 

Select air speed by setting switch to either 

low-medial-high-off.

OFF

LOW

MED

HIGH

Care and Maintenance
Cleaning: 

CAUTION-Before cleaning the fan be sure to 

disconnect power cord from the plug.  Clean the grille surface 
with a clean damp cloth. Do not use harsh chemical or abrasive 
cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN 
WATER. Replace front grille before fan use. Allow fan to dry 
completely before use. Periodic grille cleaning with a vacuum will 
prevent dust build up. The motor is sealed and does not require 
any interior maintenance, cleaning or lubrication.

Maintenance:

 The Internal motor bearings are permanently 

lubricated at the factory and do not require any additional 
lubrication.

Repair:

 DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN 

PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR 
BECOME DAMAGED IN ANY WAY.

Storage:

  Keep original carton for storage of the fan. Coil and tie 

the power cord to avoid damage during storage.

SETTING OSCILLATING MODE

1. TO MAKE THE FAN OSCILLATE: Press down the

oscillation knob at the top of the fan head

.

(See Figure A.)

2. TO STOP THE FAN OSCILLATE: Pull up the oscillation

knob at the top of the fan head.

(See Figure 

B

.)

EXTENDING THE STANDING POLE

Loosen the 

height adapter

 

on the standing 

pole .

Then pull the 

upper 

inner tube

 

of the standing 

pole  to the

 

desired height 

and re-tighten 

the height 

adapter 

Отзывы: