Glide SERIES 8, Руководство пользователя

Страница: 8 / 32

MODIFICATIONS WARNING!
Never make any modifications or use non-approved Glide Rehabilitation Products parts
on your power chair. Doing so may cause a safety hazard and could void Warranty.
Unauthorised changes constitute remanufacturing of the power chair. This voids any
warranty. The person or group who make the changes will have full liability of the
power chair.
SECTION 4. OPERATING YOUR POWER CHAIR.
CONTROLLER
Your new Power Chair has the option of two types of control systems, Dynamic
Controls or Penny & Giles Controls. You will have been given instruction on how to
operate your controller at time of specification.
WARNING:
Never push the On /Off button or pad on the control box until you are
seated correctly in the chair and have your hand on the control box.
IMPORTANT:
Please familiarise yourself with the individual functions of your
controller in particular the On\Off button or pad. Both types of control systems have an
On/Off button or pad that operate by pressing once for ON and pressing the same button
or pad again for OFF.
1. Do Not displace the joystick when pressing the on button or pad.
2. Never press the On/Off button or pad while driving your power chair.
3. To avoid damage to motor gearboxes always come to a complete “stop” before
turning your power chair off.
ARMRESTS
The armrests are adjustable in height, position forward or aft of arm pad and flip up
behind backrest.
Height Adjustment
Loosen Turn Wheel located on outside of armrest Post. When adjustment is complete
retighten Turn Wheel
firmly.
Forward and Back Adjustment of Arm Pad
Loosen small turn wheel located on the outside and underneath arm pad. Retighten
when adjustment is complete.
Flip Up
To enable armrest to flip up simply depress release lever located on inside of, and at the
base of armrest post. Lift armrest up until release lever locks into position.
FOOTRESTS
The footrests are swing away and detachable. They swing out by pulling the release
lever.
When lever is released the footplate will simply swing out and lift off the two locating
pins.
When refitting footrest to chair ensure that it is located on both locating pins. Damage
may result if only one pin is used.