COMMERCIAL
ALUMINUM REEL SYSTEM
FOR INGROUND POOLS
Youngstown, OH 44510
www.glipoolproducts.com
#4399000
INSTRUCTIONS
Fasten
With
Axle
Bolt
POLE SET
ASSEMBLY:
Minimum
9"
Overlap
Fasten with
2 Bolts at each join
(pre-drilled in outer tube)
Fasten with
2 Bolts at each join
(pre-drilled in outer tube)
Fasten
With
Axle
Bolt
Measure Plug Surface To Plug Surface
8. Attach Straps to Tubes:
Come in 6 inches from each tube end and attach a strap plate to the aluminum tube assembly. Use the self drilling screws
on the drill line to attach the plate. Look at the holes that were pre-drilled at the factory and use the same drill line. There
are 6 lines on each tube. Take the remaining strap plates and connect them evenly along the length
of the tube assembly. Attach Straps to strap plate. (See Figure D Above)
9. Attach Solar Blanket to Straps:
If Reel is to be placed at the end of the pool, attach cover to strap plate with plastic screw
as shown in Figure E Below Left. If Reel is to be placed in offset position, then attach cover
to strap plate forming a fold to act like a hinge and the plastic screw will go through two layers
of the solar blanket as shown in Figure F Below Right.
Bubbles should face down.
Solar Blanket
Strap & Bracket
Plastic Screw
Twist
Tubing To
Remove Excess
Play Prior To Screwing
Together.
Thread
Strap
as Shown
Fig. C
Fig. D
Fig. E
Fig. F
Solar Blanket Folded
Plastic Screw
Strap & Bracket
TUBE KIT ASSEMBLY:
• Loosely assemble extruded tubes together. Slide excess width into adjoining tubes, dividing it up as equally
as possible.
Note: You must have a minimum of 9” of overlap in each tube!
• Measure the width across the pool from plug surface to plug surface & adjust length of the tube assembly to fit the span.
• Lock the tubes together by rotating each adjoining tube in the opposite direction. (See Figure C Below)
• Attach the tube assembly into the Crank and Tubing Plugs and check for fit. Assemble Tube assembly together with
Crank Handles and Tube Plugs by lining up hole in the end of each tube fitted into Crank Handle and secure with metal
Axle Bolt and nut provided.
• When all is OK drill holes for the through bolts to connect the tubes. Use the pre-drilled holes in the outer tube as a guide to drill the
smaller inner tube. Drill from each side with the drill bit supplied.
• Fasten with 2 Bolts & Nuts at each join. Bolts are at right angles to each other
