Page
15
of
26
Running Dante Controller
At the time of writing this manual the Dante Controller looks as per the screenshot
below:
The Comedia will have been named at the factory during test to allow them to be
identified by the Dante® controller.
The format used for the factory name is:
‘Comedia-01-sn-XXXXX’
Where ‘Comedia-01’ refers to the Glensound product i.e. Comedia type 1.
The ‘–sn-XXXXX’ refers to the serial number of the Comedia which can be found
printed on the rear label of the unit.
The unit may be renamed in Dante® controller by opening the ‘Device view’ window
and selecting Comedia -01-sn-XXXXX in the drop-down menu. Go to the
‘Device
Config’ tab and change the name with the Rename Device box.
Note if you upload a new DNT file or clear the devices config then the name will
change to Comedia -01-
xxXxXx whereby the ‘X’s refer to the devices MAC address.
Dante Controller TIP
If you have never run Dante controller before then make sure that on the bottom left
of the Dante controllers’ screen ‘P’ or ‘S’ is next to a green square as this indicates
that it is connected t
o a network. By clicking ‘P’ or ‘S’ a pop up box opens to allow
you to set what network interface the controller is using.
