Glensound Copper 29, Руководство пользователя

Страница: 14 / 14

Serial response and error messages.
Message
SYSTEM_START_3 DSP1 has rebooted
OFF_HOOK TBU has gone off hook
ON_HOOK Front panel switch or DC loop has caused TBU to go on hook
+ON_HOOK K-BREAK has caused TBU to go on hook
*ON_HOOK Disconnect tone has caused TBU to go on hook
RING TBU is ringing
AUTO_ANS TBU has auto answered a call
E_FR DAA chip set Framing error
E_LC Telephone line under or over current fault
E_BF RS232 Serial buffer full
E_RO DAA receiver overload
E_IC An invalid character was sent to the RS232 interface.
E_COM Communications error with DSP2 or CPLD
POLI Line Polarity inversion detected
DODI Line drop out (K-BREAK) detected
Operation
Making a call
Connect the Copper 29 to the telephone line and audio interfaces as required.
Connect a telephone to the 'handset' socket on the rear panel.
Dial the number required using the telephone.
Divert the call to the TBU by pressing the off hook button on the TBU. The telephone will be disconnected and
the call will be diverted to the TBU.
Adjust the level controls as required.
When the call has ended, hang up the TBU by pressing the on hook / off hook button for ~2 seconds.
To answer an incoming call press and release the on hook / off hook button.