Page
25
of
26
Running Dante Controller
At the time of writing this manual the Dante Controller looks as per the screenshot
below:
The Beatrice will have been named at the factory during test to allow them to be
identified by the Dante controller.
The format used for the factory name is:
‘Beatrice-ob7a2c-serial-125’
Where ‘Beatrice-ob7a2c’ refers to the Glensound product i.e. Beatrice and its MAC
address.
The ‘–serial-125’ refers to the serial number of the Betarice which can be found
printed on the rear or side of the unit.
Dante Controller TIP
If you have never run Dante controller before then make sure that on the bottom left
of the Dante controllers’ screen ‘P’ or ‘S’ is next to a green square as this indicates
that it is connected to a network. By clicking ‘P’ or ‘S’ a pop up box opens to allow
you to set what network interface the controller is using.
