PAGE 3 of 7
001-193
Accu-Finish Protractor Extension Arm
Order #001-822
G
S E R I E S I I
TABLE
ANGLE
LEVER
HANDLE
TABLE
LOCK
DIAMOND
WHEEL
TOOL
GUIDE
TABLE ANGLE
PROTRACTOR
TO SET
TOOL CLEARANCE
(RELIEF)
WHEEL
ANGLE
PROTRACTOR
S E R I E S I I
LOCATOR
BLOCK
D
E
Table Position
The vertical wheel position allows
use of the calibrated table and
tool guide. Two tool angles can be
simultaneously controlled.
Tool clearance (relief) can be
adjusted by setting the table
elevation. To set table elevation:
1. Slide table to the right.
2. Pull the table lever handle left
to free the table, allowing you to
change the angle.
3. Set the elevation scale to desired
degree (0° is square to wheel).
Tighten locking knob (D).
NOTE: To ensure proper elevation
accuracy, the hinged surface between
the main motor housing and the side
support arms must be kept clean.
Make sure that no metal particles or
obstructions are stuck to the holding
magnet or their mating surfaces.
The table is factory calibrated, but
you may want to calibrate it yourself
sometime in the future. With the
table angle unlocked, place a square
against the table and wheel, then lock
the table. This is a perfect 90° -OR-
0° on the angle protractor. Loosen the
locator block and align mark with the
0° mark on the protractor and tighten
the locator block (E).
The tool guide is adjustable to 75º
either side of 0º. Loosen the knurled
locking screw in the tool guide. Set
angle to desired degree on scale and
tighten locking screw.
Tool Guide
For angles greater than 75º, obtain
a piece of flat material about 2" – 3"
square by 1/8" – 1/2" thick. Place this
square block against the tool guide
(F). Working from the 90º offset lets
you set all angles.
Accu-Finish offers a Protractor
Extension Arm (#001-822) that
clamps to the tool guide. This makes
it easier to hold the tools while
sharpening (G).
F
COUNTER CLOCKWISE
“OFF” POSITION
CLOCKWISE
READ ALL DIRECTIONS before attempting
setup or installation of this machine.
