Installation
The integrated rangehood can be installed in either ducted or
re-circulating method. The integrated rangehood is supplied
with a small length of flexible duct, although may not be
sufficient in all installations. The installer needs to determine
the method in which the rangehood will be installed and may
need to supply the appropriate components to duct the
rangehood correctly.
Ducting components will need to be supplied by the installer as
every installation can be different. The size of the duct pipe
needs to be no less than 150mm in diameter. Use of
smaller diameter duct pipe will effect performance and create
air noise from the rangehood
.
Re-circulation installation
150mm flexible duct is provided with the integrated rangehood for
re-circulatiing installation. This type of installation can be executed to
the top of a cupboard or through a bulkhead above the cupboard. In
both cases a mesh cover will need to be supplied by the installer to
keep out insects and vermin. The size of the duct pipe needs to be no
less than 150mm in diameter. Use of smaller diameter duct pipe will
effect performance and create air noise from the rangehood.
The shelf above the top of the rangehood needs to removable, should
the need for servicing be required at a later date. The shelf needs to
be located no less than 400mm above the top of the rangehood as the
metal motor housing supplied needs to be put in place after the
rangehood has been installed. Above the shelf a U-shaped box can
be made to cover the duct so it cannot be seen when the overhead
cupboard is open. (Fig.6)
13
