Glen Dimplex 7809-C15-BB, Инструкция по установке и эксплуатации

Страница: 7 / 13

7
1 Ensure the wall bracket is installed on a flat surface and the grilles on the back of
the heater are not obstructed.
2 Release mounting bracket by pressing and pulling the locking tab on the back side
of the heater using a flat screwdriver (Fig. 2).
3 Position the mounting bracket on the wall and ensure it is level horizontally. Mark
and drill the 3 fixing holes (Fig. 3).
4 Replace mounting bracket and fasten it with appropriate screws and anchors.
Ensure that the correct screws, and anchors if necessary, are used to allow the
unit to be securely mounted on the wall. It is recommended that at least two of the
screws are attached to studs in the wall.
Fig.3
Fig.2
A = 9 1/16" (23 cm)
B = 3" (7,6 cm)
C = 4 23/32" (12 cm)
D
(to the floor)
= 74 1/32" (188 cm)
NOTE 1: Follow the clearances shown in Fig. 1.
NOTE 2: The unit must be secured on the wall
bracket. The use of adhesive to install the bracket
or the device is prohibited.