14
2.
Depending on the type of panel, drill 12 holes in the ceiling (see Fig. 2). Twelve ST6*40 mm large flat screws will be
used to fasten the panel to the ceiling, and 8 M4*10 screws and an M4 nut and washer will be used to attach the angle
iron to the panel (see Fig. 1). After calculating the length of the angle iron, use 16 M4*10 large flat screws and one M4
nut and washer to attach the angle iron and an additional angle iron (the overlap between the angle irons should not
exceed 100 mm).
3.
Pass one end of the extensible pipe through the 170 mm hole (see Fig. 3).
4.
Use 4 ST4*8 large flat screws to connect the internal chimney to the panel that will be used to suspend the hood. Lift
up the external chimney and hang it to the two hooks before the next installation steps (see Fig. 4).
5.
Install the outlet using 4 ST4*8 large flat screws (see Fig. 5).
6.
Adjust the 4 glass screws to make sure the glass and the unit’s body are properly attached and fastened (see Fig. 6).
7.
Holding up the unit, connect the body to the angle iron using 16 M4*10 large flat screws (see Fig. 7).
Place the extensible pipe on the outlet. Once everything is as required, pull the hood and the chimney down, thereby
completing the installation (see Fig. 9).
Fig.
1
Fig.
2
Fig.
3
Fig. 4
Содержание GHB970IX
