Parts required to join Two (2) Cabinets:
Cabinet
Connector
Screws
Qty
Screw Qty
depth
Part#
Qty
Caps
4” deep
#426
3
10-32 x 1 1/2” 12
#434 12
6” deep
#429
3
10-32 x 1 1/2” 12
#434 12
Left Top
Right Top
Left Top
Center Top
Right Top
Left Top
Right Top
Section 1
Cabinet Flanges
meet here
5
Combining Two (2) or Three (3)
Cabinet Units before Installation.
Any of the cabinets that are the same height may be
joined to form one unit. Follow these instructions to cre-
ate the final size unit before attempting installation.
• Be sure to determine the hinge side door swing
location for each unit.
• Mark the top of each unit-- Left, Right or Center with
the Hinge plates in the proper position.
When the unit is fully assembled refer to “R.O.” formula
chart on page 3 to determine the R.O. required for the
unit as assembled.
Assembling multiple cabinet units:
1. Place the units on a 2x4 or 2x6 of sufficient horizontal
length to support all the units to be joined. Place 2” edge
of the wood flat on the floor with the cabinet facing up
with the bottom flush to the inside edge of the 2x4.
2. Install the Cabinet Connector (part #426 or 429) on the
outside of the left hand cabinet. Use the pre-punched
holes immediately above and below the hinge plate loca-
tions. Use screws 10-32 x 1/2” as supplied. (See Section
#1)
3. Move the second cabinet into position so that the face
flange of both units are aligned. Fix the cabinets together
using screws 10-32 x 1/2” as supplied. (See Section #1).
4. If there is a third unit follow the steps above.
Shown here -- Left, Right and Right
hinge side door swings
Shown here -- Left and Right
hinge side door swings
Parts required to join Three (3) Cabinets:
Cabinet
Connector
Screws
Qty
Screw Qty
depth
Part#
Qty
Caps
4” deep
#426
6
10-32 x 1 1/2” 20
#434 20
6” deep
#429
6
10-32 x 1 1/2” 20
#434 20
Drawings not shown to scale
for Full-Length
Mirrored Cabinets
