3
IMPORTANT SAFETY INSTRUCTIONS
1) This heater is hot when in use. To avoid burns, DO
NOT let bare skin touch hot surfaces. If provided, use
handles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3feet (0.9m) from the
front of the heater, and keep them away from the
sides and rear.
2) Extreme caution is necessary when any heater is
used by or near children and whenever the heater
is left operating and unattended.
3) DO NOT operate any heater with a damaged cord
or plug or after the heater malfunctions, has been
dropped or damaged in any manner. Discard heater,
or return to authorizedservice facility for examination
and/or repair.
4) DO NOT run power cord under carpeting. DO NOT
cover power cord with throw rugs, runners, or similar
coverings. DO NOT route power cord under furniture or
appliances. Arrange power cord away from traffic area,
and where it will not be tripped over.
5) Connect to properly grounded outlets ONLY.
6) DO NOT insert or allow foreign objects to enter any
ventilation or exhaust opening, as this may cause
electric shock or fire, or damage the heater.
7) To prevent a possible fire, DO NOT block air intakes or
exhaust in any manner. Doing so could cause a fire.
DO NOT use on soft surfaces, like a bed, where
openings may become blocked.
8) A heater has hot and arcing or sparking parts inside.
DO NOT use it in areaswhere gasoline, paint, or
flammable liquids are used or stored.
9) Use this heater only as described in this manual. Any
other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons.
10) ALWAYS plug heaters directly into a wall outlet/
receptacle. NEVER use with an extension cord or
relocatable power tap (outlet/powerstrip).
11) DO NOT place the heater near a bed because objects
such as pillows or blankets can fall off the bed and be
ignited by the heater.
12) NEVER use this heater in bathrooms, laundry rooms,
or any other location where the heater could fall into a
bathtub or pool, become damp, or come in contact
with water.
13) AVOID FIRE! Regularly inspect all air vents to make sure
they are free from dust, lint, or other blockage. Unplug
the unit and clean with a vacuum ONLY.
DO NOT rinse or get wet.
14) ALWAYS mount to wall bracket before use. DO NOT set
on the floor, or other surface, to use.
15) NEVER use a wall mount bracket from another
manufacturer.
16) This product is not intended to be a primary heat source.
It is for supplemental heat only.
17) INDOOR use only! NEVER use this heater outdoors!
Doing so may result in electric shock!
18) Risk of electric shock! DO NOT OPEN!
No user-serviceable parts inside!
19) ALWAYS turn this heater off before unplugging it from the
outlet.
20) ALWAYS disconnect this unit from the power supply
before performing any assembly or cleaning, or before
relocating the electric fireplace.
21) NEVER leave this heater unattended. ALWAYS unplug this
heater when not in use.
22) ALWAYS store this heater in a dry location. NEVER use
the fireplace if it has become wet.
23) NEVER plug this heater into an outlet that is old,
cracked, or has any loose wires or connections.
Plugging this heater into a faulty outlet could result in
electric arcing within the outlet that could cause the
outlet to overheat or catch fire.
24) ALWAYS check your heater cord and plug connections
with each use!
i) MAKE SURE the plug fits tight in the outlet!
Faulty wall outlet connections or loose plugs can cause
the outlet to overheat.
ii) If the outlet or face plate is HOT, discontinue use
immediately and have a qualified electrician inspect
and/or replace the faulty outlets.
25) The power cord supplied with
the heater has three prongs:
two flat blades (live and neutral)
and one round pin (ground). If a
3-slot receptacle is not available, an
adapter MUST be used. The adapter MUST
be properly grounded to the outlet box (see figure at
right). [NOTE: Adapter NOT INCLUDED.]
WARNING
!
SAVE THESE INSTRUCTIONS!
READ ALL INSTRUCTIONS BEFORE USING THIS HEATER!
