Figura 8.
8.
Hang the fireplace from the bracket.
9.
Install the removed screw through the bottom support bracket into the fireplace.
10.
Refer to Front Glass Installation section final installation procedures.
3.1.2.2 MONTAGEM À SUPERFÍCIE (Luminous 1200)
1.
Choose a location which has a minimum of two wall studs available for mounting.
2
.
Choose your method of supplying power to the unit: • Plug in to an existing outlet or install an outlet nearby. •
Hard wire the fireplace. Follow the hard wiring instructions on page 7.
WARNING:
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury
to persons, always use a licensed electrician.
Ensure that the circuit on which the fireplace is to be installed has the power cut off at the service panel until installa-
tion is complete.
3.
Remove the partially reflective glass from the fire:
Lay fireplace on its back.
Remove Phillips screws from each of the two glass brackets (figure 9).
Remove glass brackets.
With one hand keeping pressure on the partially reflective glass, tilt the
fireplace upright and slightly forward to allow the partially reflective
glass to fall out of the inside framing.
CAUTION:
Partially reflective glass is not tempered. Do not bump or drop the
partially reflective glass to avoid breakage and personal injury.
Remove partially reflective glass from fireplace.
Parafusos de suporte
Vidro parcialmente
refletivo
Suporte do vidro
Figure 9.
