GlammFire Lum 1500, Руководство пользователя

Страница: 10 / 16

2 - GENERAL
WARNING
–
THIS APPLIANCE MUST BE EARTHED
This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply
voltage.
Do not switch the appliance on until properly installed. Please read all the safety warnings and operating instructions.
Unpack the heater carefully and retain the packaging for possible future use.
Contents of Carton
- Electric fire
- Wall fixing bracket.
- Fixing screws and wall plugs.
-
Remote control and batteries (AAA’s type).
Do not connect the heater to an electricity supply until it is installed on a wall correctly -
see ‘Installation’.
A choice of 1KW or 2KW heat output is provided by the fan heaters which are concealed within the unit.
The heater can be used remotely or manually -
see ‘Operation’.
General features of remote control are:
-Flame picture can be turned On or Off.
-Heat output can be increased or decreased according to your particular requirements.
PLEASE NOTE: Used in an environment where background noise is very low, it may be possible to hear the motor
which operates the flame effect. This is normal and should not be a cause for concern.
3 - INSTALLATION
Safety Message
- Sufficient expertise is required for installing this product. If unsure we recommend that you subcon-
tract the installation and pay special attention to safety during the installation.
Wall Installation
Do not connect appliance until properly fixed to the wall and the Instruction leaflet is fully read. In particular, the
minimum distances must be observed.
For installation of the appliance, care must be taken not to damage concealed cables.
Please be careful while drilling the holes.
The wall plugs supplied with this product are for use with Block/Brick built walls only.
This model is designed to be permanently fixed to a wall at a minimum height of 300mm. The wall bracket must be
fitted horizontally and the cable routed to the bottom right of the appliance shown as “a” in
Fig. 1 .
A height of 600 to 725mm from bottom of the appliance to floor is recommended for optimum viewing of fuel bed
(see
Fig. 2
for recommended fixing dimensions).
For optimum viewing mark the top four screw fixing positions on wall in accordance with the recommended fixing
dimensions - see
Fig. 2
. Drill holes with a 6mm drill bit.