Gladen ATM 2, Руководство пользователя

Страница: 3 / 8

1. disconnect the battery
Disconnect the ground connection of the battery before starting the installation.
Observe the vehicle manufacturer's information!
2. ground connection (black)
Connect the GND / ground wires to the vehicle ground (body). Ensure good contact.
The lines should be as short as possible.
3. +12V connection (yellow)
Connect the +12V lines to the positive pole of the battery. A sufficient diameter of the cable is to be noted. The
power cable must be protected with a suitable fuse (20A), this must not be more than 30cm away from the
battery pole.
4. remote connector (blue) - low level operation only!
Connect the remote / power-on line to the corresponding output of the radio. For High Level connection
(speaker outputs), this connection is not necessary.
5. signal connection (white / grey with RCA jacks)
Connect the signal inputs to the outputs of the radio. The connection can be made to Low Level (RCA) or High
Level(speaker outputs). The input selector switch (High/Low) must be set accordingly.
With High Level connection the signal lines must not be connected to each other!
Connections
Connection Harness (Mains)
Signal left
Signal right
Remote on
Ground
+12V
1