6
Installation (continued)
Place the basket (L) and sink grid (K) into the sink.
Installing the strainer
5
AA
A
7
Installing the basket and grid
K
C
D
E
F
G
A
H
I
J
Install the strainer assembly as these steps describe. It is easier to install the
strainer assembly to the sink before the sink is installed to the cabinet.
1) Apply a small amount of plumber’s putty (not included) in the notch around the drain
hole of the sink (A). Place the strainer ring (E) on the top of the drain hole in the sink (A).
2) Insert the screener (C) into the bowl (D) and place this assembly into the drain hole
in the sink (A).
3) From underneath the sink (A), place the rubber washer (F), paper washer (G),
locknut (H), plastic joint (I), and connecting nut (J) over the drain hole in the sink (A).
4) Tighten the locknut (H) and connecting nut (J) to hold the strainer assembly
securely in place.
L
□
□
□
□
Apply a bead of silicone around the perimeter of the top of the sink.
Position and align the hollow beneath the sink countertop.
Once the sink is in the correct position, install the mounting clips (AA). Tighten the mounting clips (AA) until the sink rim is aligned to the
countertop. Check the alignment while squeezing, so that the front of the sink (A) is parallel to the countertop. Adjust and retighten if
necessary. Do not overtighten.
Clean the excess sealant with a rag.
Installing the sink
6
Screw
