7
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-800-247-1087 for further assistance.
Installation (continued)
2
Installing the faucet
Installing the faucet
Installing the faucet
Installing the faucet
IMPORTANT
:
:
:
: To avoid damaging the sink, consult a
qualified plumber or installer for drilling procedures in
porcelain or stainless steel. Special drill bits are made for
this.
Before you begin, ensure there is room underneath
the sink or countertop so you can make the needed
connections. If drilling is required in the sink top or
countertop next to the sink, make a 1-1/4 in. dia.
(minimum) hole for the faucet (C).
□
Insert one end of the blue tube into the faucet (C)
(see Step 3 – Connecting the tubes). Feed the
other end of the blue tube through the mounting
hole.
□
Slide the toggle bolts through the mounting hole
until the faucet (C) base is square against the
mounting surface (sink or countertop). Tighten the
toggle bolts to secure the base flat on the
mounting surface. Do not over-tighten.
□
Turn the faucet (C) 1/4 clockwise to attach the
faucet (C) to the base.
3
Connecting the tubes
Connecting the tubes
Connecting the tubes
Connecting the tubes
Remove and discard the protective foam plugs (if
present) before connecting tubes.
□
Allowing some slack, measure and cut a length of
3/8 in. tubing (D) to connect between the supply
fitting and the filter system inlet. Cut the ends of
the tubing square.
□
Insert tubing all the way into the supply fitting
and inlet fitting. Pull on the tubing to be sure that
it is securely set in the fittings.
□
Repeat the first two bullets to connect the tubing
from the faucet to the filter system outlet.
Tubing Connecti
Tubing Connecti
Tubing Connecti
Tubing Connection (all push
on (all push
on (all push
on (all push----in fitting
in fitting
in fitting
in fittings):
s):
s):
s):
This system includes push-in fittings for quick tubing
connections. If working with the fittings, do the
following:
□
Cut the end of the tubing square. Inspect the end
(about 1 in.) of the tubing to be sure there are no
nicks, scratches or other rough spots. If needed,
cut the tubing again.
□
Push tubing through the collet and through the
fitting. Full engagement is 3/4 in. length of tube
into the fitting. If tubing other than supplied with
the system is used, be sure it is of high quality,
exact size and roundness with a smooth surface.
C
1/4 turn to connect
faucet to base
Toggle bolt
Screw
Faucet base
Rubber washer
Hole in sink
or counter
End of tubing round and smooth,
with no cuts, nicks or flat spots
Correct full 3/4 in. engagement
Tubing correctly cut and connected
Incorrect partial engagement
To disconnect, push the collet inward and
hold with a finger while pushing the tubing out:
Remove and discard foam plugs
Foam plug
Push in fitting
Содержание HDGMBS4
Страница 4: ...4...
