11
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-800-247-1087 for further assistance.
Installation (continued)
5
Installing
Installing
Installing
Installing the faucet
the faucet
the faucet
the faucet
Mount faucet (D) base to the sink hole until the faucet
base is flat against the sink surface. The rubber gasket
should be between the sink surface and the faucet base.
Tighten the toggle bolts until the base is firmly mounted to
the sink surface. Do not overtighten.
Insert the black and blue tubes attached to the faucet
body (D) into the sink hole until approximately one foot of
tube length and the faucet body (D) are left above the
counter surface. Do not kink the tubes in the process.
NOTE
If you routed the red drain tubing directly to a
remote drain point, disregard step 5 and move on to step
6.
Connect one end to the red collet fitting on the top of the
reverse osmosis filtration system. See the diagram in Step
9.
□
Route the loose end of the red tube through
countertop to faucet.
□
Cut the loose end of the red tube square and to
length. See Step 7 for cutting the tubes.
Tubing lengths should allow for the removal of
the assembly from the hanger washers for
servicing. If tubing lengths are shortened for
neater appearance, it may be necessary to keep
the assembly on the hanger washers for service.
□
Insert all the way onto the 1/4 in. faucet barb
fitting on the faucet.
Pull on the tubing to be sure it is held firmly in
the fitting.
□
Mount the faucet body (D) onto the faucet base,
1/4 turn.
D
Rubber
gasket
Toggle
bolts
Faucet•
base
Amber LED
Screw holding the
battery housing in place
Timer housing
Battery
housing
Screw
Battery
negative (-) side
facing the front
Faucet•
base
