TOOLS REQUIRED
Claw hammer
Safety goggles
Phillips screwdriver
Power drill
Measuring tape
Wall hardware
Caulk/sealant
Masking Tape
Level
HARDWARE INCLUDED
AA - Knobs
x 4
BB - Short
Screws x 2
CC - Long
Screws x 2
DD - 1/4 in. Spacers x 2
Use and Care Guide
Floor Hutch
Item #1001 768 028
Model #DSDECWHT12
Wall-Vanity-Hutch-Vanity Configuration:
A 5/8 in. spacer is needed
to allow the Floor Hutch to be secured flush with the first Vanity Unit. The
5/8 in. spacer is available through customer service (free of charge).
The two 1/4 in. spacers (DD) provided are used to install the second
Vanity Unit flush with the Floor Hutch. The top overhang will be shifted
to the outer side of the Vanity Unit. The Floor Hutch top will be centered.
Hutch-Vanity-Hutch-
Configuration:
When the Vanity
Unit is installed with two Floor
Hutches, four 5/8 in. spacers
are needed. The 5/8 in. spacers
are available through customer
service (free of charge). After
installation, use silicone to seal
the space between the Vanity
Unit top and Floor Hutch side
panel (A). The Floor Hutch tops
will be centered.
OVERHANG
1/4 IN. SPACER (DD)
5/8 IN. SPACER
1/2 IN. OVERHANG
WALL
5/8 IN.
SPACERS
Configuration Options
Stand-Alone Configuration:
If a Vanity Unit and Floor Hutch
are installed separately, there
is no need to use the 1/4 in.
spacers (DD) provided with the
Floor Hutch. The tops will be
centered on unit(s) with equal
overhang
.
Wall-Hutch-Vanity Configuration:
The two 1/4 in. spacers (DD)
are used to allow the Floor Hutch to be secured flush with the Vanity
Unit. Both tops will be installed flush on one side and the 1/2 in. top
overhang will be shifted to the opposite side.
Vanity-Hutch Configuration:
If a Vanity Unit and Floor Hutch are tied
together but not butted against a wall, the two 1/4 in. spacers (DD)
are used to tie the Floor Hutch and Vanity Unit together. The 1/2 in. top
overhang is shifted to one side of the Vanity Unit. The Floor Hutch top
is centered on the unit with equal overhang.
EQUAL OVERHANG
OR
OVERHANG
1/4 IN. SPACER
(DD)
1/4 IN. SPACER (DD)
TOP OVERHANG
WALL
1/4 IN.
SPACER
(DD)
Wall-Vanity-Hutch Configuration:
A 5/8 in. spacer is needed to
allow the Floor Hutch to be installed flush with the Vanity Unit and
provide space for the top overhang between the Vanity Unit and
Floor Hutch. The 5/8 in. spacer is available through customer
service (free of charge).
WALL
OVERHANG
5/8 IN. SPACER IS USED TO FILL
GAP BEHIND THE FACE FRAME
AND TIE THE UNITS TOGETHER.
A
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-888-774-8062 for further assistance.
