6
Operation (continued)
Troubleshooting
Problem
Possible Cause
Solution
There are leaks from the
handle.
The bonnet nut has come loose and/or the
washer is dirty or damaged.
□
Tighten the bonnet nut.
□
Clean or replace the washer.
The aerator has an
irregular or reduced
water flow.
□
Remove the aerator and
check for debris.
□
Ensure that the rubber washer
is properly installed.
The water will not shut off
completely.
The rubber seat and spring is dirty or
broken.
□
Remove the cartridge to check
the rubber seat and spring.
□
Clean or replace.
The aerator is dirty or mis-fitted.
NOTE:
Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
2
Removing the quick connector
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
Squeeze
2
Pull
down
1
1
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
