Glacier bay 1005403614, Инструкция по использованию и уходу

Страница: 15 / 36

13
Removing the quick connector
If it is necessary to remove the quick connector (1),
squeeze the tabs (2) on the quick connector and then
pull down to disconnect.
Pull
down
Squeeze
1
1
2
8
Installing the soap dispenser
From under the sink, screw the soap dispenser (T) onto the
soap assembly (O) shank. Insert the soap pump (Q) down
into the soap assembly (O).
Insert the soap assembly (O) through the selected hole
in the sink. Secure the soap assembly(O) to the sink with
9
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
overtighten.
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
other and damaging.
Q
Topmount Installation (continued)
14
HOMEDEPOT.COM/GLACIERBAY
Undermount Installation (continued)
15
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each