- 4 -
1 X
LUX ‘S’ OUTPUT ONLY:
a) 2 lux to 240 lux. = the approximate
light level at which the ‘S’ output is
activated.
b) 24 HOUR = will operate day and night.
All other outputs operate day and night
irrespective of the ‘S’ output setting.
PULSE COUNT:
The range of the unit will decrease if there is
little difference in temperature between the
moving object and the background.
1 will give a fast response
2 gives better immunity with good
response
3 gives higher immunity to false
activation
Timing 1 (2 & 3
<
6 seconds)
TIME 'CCTV' OUTPUT
This is the time in seconds that the 'CCTV'
volt free output will activate after detection.
For setup purposes the respective channel
indicator will also light for this time. Adjust
the jumper link on the RFX-3 Receiver to
select either normally open in alarm condition
or normally closed contacts.
CUSTOMISING
All factory set parameters can be changed to
suit individual requirements. The highlighted
areas on the programming chart show the
factory settings which suit most applications.
Changes can be easily made either before
installation or on site. Once changes have been
made they are stored in a non-volatile memory.
PROGRAMMING
To amend your existing 'Option' and 'Setting'
1) Press the program button on the detector
once for the number of the required 'Option'
(e.g. range-press twice)
2) Wait 4 seconds until the LED goes out.
3) Within 5 seconds press the button again for
the number of the required 'Setting'
(e.g 20 metres-press three times)
4) The LED blinks twice - the new setting is
saved
To amend any other options/settings repeat
steps '1' to '4'
EXAMPLE -
To set the Range to 20 metres
a)
Press twice to select Range
b)
Wait until LED goes off (4 seconds)
c)
Press three times for 20 metres
Six
= will flashout your selected settings
Seven
= will reset to GJD factory default settings
Eight/hold = will start the RF continuity test (see page 5)
Nine/hold = will generate and alternative random code ( see page 5)
AU
XI
LI
A
R
Y
OPAL RFX DETECTOR PROGRAMMING CHART
6
5
2
2
2
2
3
3
3
3
4
4
4
5
5
7
8
8
6
7
Press
Twice -set Range
Three -set Lux Level
Four
-set Pulse Count
Five
-set Time 'CCTV'
1
1
1
1
10
15
20
25
35
metres
2
5
15
30
60
120 240 24hr 'S'output
1
2
3
pulse count
0.4
1
2
4
8
25
30
60
seconds
then x
for
then x
for
then x
for
then x
for
OP
T
IO
N
S
wait for indicator to go out
