Page 5 of 11
The module has three circular holes above the IN buttons. Behind the hole on the left is
the Channel 1 P2 button used for pairing the channel with a motor controller, behind
the center hole is a Red LED which will illuminate when any of the buttons are pressed.
Behind the hole on the right is the Channel 2 P2 button used for pairing the channel
with a motor controller.
INSTALLATION
The screw holes indicated in the picture above are the only ones to be used when
mounting the module. Do NOT drill any other holes in this module as this will damage
the circuit board and render the module useless. Screws are provided with the module
for this purpose. The 98GC230 has an operating range of 100’ but should be mounted
with as few obstructions as possible between itself and the Motor Controller it is paired
with.
L.E.D
Ch2 P2 Button
Screw
mounting holes
Ch1 P2 Button
