8
9
Chosen a location for your pressure hose reel, follow the figure 1 of the wall base
template to mark the location of 4 holes for drilling, or place the wall base itself up to
the wall to mark the location of the screw holes for drilling.
Use a 1/2" or 12mm diameter drill bit to drill the 4 marked holes. Hole depth is
important. You may choose to measure a 1.96in depth on the drill bit itself and mark
it with a small piece of tape so you know when you’ve drilled the appropriate depth
into the wall. Using a correctly sized drill bit will ensure a secure installation of the wall
base. To make sure the wall anchors have a secure fit, you may choose to drill a slightly
smaller hole first, then size up if it proves too small for the wall anchor.
Hammer the wall anchors into the 4 pre-drilled holes.
Place the base to the wall, aligning the wall anchors with the designated holes in the
wall base. Screw in the screws with either a socket set or a Phillips screwdriver.
Do not tamper with or adjust the safety valve setting.
Safety valve and/or pressure limiting valve.
The safety valve is also a pressure limiting valve.
When the gun trigger is released, the valve opens and the water recirculates
through the pump inlet or is discharged onto the ground.
Safety catch (see Connection of gun and hose)
Prevent accidental spraying of water.
Air outlet on plastic case and it should NOT be blocked during operation, or fire or
electric shock hazard is possible
SAFETY “MUSTS”
Caution – Danger!
1.
2.
3.
1.
2.
3.
4.
USING STEPS
Fix Wall Base
CONTAMINATION HAZARD
Maintenance and/or repair of electrical components MUST be carried out by qualified
staff.
ACCIDENT HAZARD
Shut down the appliance, cut power supply and water supply. Then, discharge the
residual pressure by triggering the gun before disconnecting the unit hose.
INJURY
HAZARD
Before using the appliance, CHECK every time that the screws are fully tightened and
that there are no broken or worn parts.
ACCIDENT HAZARD
ONLY USE detergents which will NOT corrode the coating materials of the high
pressure hose/electrical cable.
EXPLOSION AND ELECTRIC SHOCK HAZARD
ENSURE that all people or animals keep a minimum distance of 16yd. (15M) away.
INJURY HAZARD
The unit should fixed when it’s working.
This appliance can NOT be stored in damp environment;
When stopping the appliance, shut the appliance’s switch before pulling plug out;
Use only original or manufacturer approved spare parts for safety sake
Total Stop (motor stops when trigger released) does NOT always keep effective and
the appliance can NOT be at Total Stop for long time. If ineffective ( for inner seal
damaged, local voltage too low etc), MUST turn off the switch to stop the machine
during working;
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
