System 3000
Brightness and temperature sensor BT
Figure 4: Inserting the battery
￭
Slide battery into battery holder (Figure 4). Observe polarity: the positive pole of the bat-
tery must be at the top.
Figure 5: Engaging the circuit board
￭
Note MAC address (3) (Figure 5). This address is required for assignment to the cover.
￭
Insert the circuit board in the housing base. Firstly, push the circuit board up to the front
side of the housing and then push the rear section of the circuit board downwards
(Figure 5).
Figure 6: Close housing
￭
Reattach the housing lid and push the housing together until it locks into place. (Figure 6).
The device is ready for operation.
Assigning the sensor to the cover
The sensor transmits the brightness and temperature values every 5 minutes and when the
brightness or temperature changes. The sensor must be assigned to the cover so that it can
process the measured values of the sensor. This assignment is done via the app.
￭
Select "Add sensor" in the app configuration.
An input field for the MAC address of the device will appear in the app.
￭
Enter the MAC address (3) in the input field.
3 / 5
82599912
05.03.2020
