3
Setting up energy profile
Condensation water opening
Before mounting the energy profile, open the
condensation water drain on the bottom of the
profile base. For this purpose, knock out the
opening (see arrow) and remove the burr with a
file.
The energy profile is fastened with only one bolt.
Depending on the conditions of the foundation,
there are two options for anchoring the energy
profile to the ground.
With an underground tube
The energy profile is set up using the
underground tube on loose or soft ground, e.g. in
flowerbeds or on grass.
1. Dig a hole approx. 50 cm deep at the
intended mounting site.
2. Guide the cables through the underground
tube and cement the tube in vertically and
flush with the surface.
3. Guide the cables through the profile base.
4. Mount the profile base to the underground
tube with the accompanying hexagon bolt.
5. Guide the cables into the accompanying
conduit boxes and connect the plastic-
sheathed cables which reach the device
units.
6. Connect the lighting element (if present)
7. Connect the earth cable of the energy profile
to the earth terminal of the profile base.
8. Place the energy profile on the profile base
and fasten it with the three Allen bolts
(M6 x 14).
9. For energy profiles with a lighting element,
insert the light and close the profile with the
cover.
Attention
The installation and assembly of electrical
equipment may only be performed by a qualified
electrician.
Position of the underground tube
Note the position of the energy column when
cementing in the underground tube It can be
aligned by max. 20° on the underground tube.
i
Profile with no lighting element
For profiles with no lighting element, all devices
and TX_44 cover frames must be mounted
before the profile cover is set in place. To keep
the profile splash-resistant, the top edge of the
TX_44 cover frame must be flush with the top
edge of the profile.
