GIRA
Info
LED-Clock/Alarm Clock/Thermometer 230 V~
Instructions for Installation
LED-Clock/Alarm Clock/Thermometer 230 V~ 03/99
Page 3 of 4
Setting the Alarm Time
Alarm Time 1:
1. Wait or change (see: Display Alternation On/Off) to the time display.
2. Press the button
until the symbol for alarm time 1 blinks.
3. Hold the button
down and set the alarm time with the buttons H and M. To advance quickly,
hold the button H or M down.
4. After setting the alarm time, release the button
.
Alarm Time 2:
The adjustment of the alarm time 2 takes place as with the setting of alarm time 1. The button
must only be pressed long enough that the symbol for alarm time 2 blinks.
Switch Alarm On/Off
Alarm Time 1:
1. Wait or change (see: Display Alternation On/Off) to the time display.
2. Press the button
until the symbol for alarm time 1 blinks.
3. Release the button
and then briefly press the button
again to switch the alarm on or off.
4. The alarm time 1 is switched on when the symbol lights up.
Alarm time 2:
The alarm time 2 is switched on/off as with alarm time 1. The button
must only be pressed long
enough that the symbol for alarm time 2 blinks. Then, release the button and press briefly again.
Switch Alarm Sound Off
Press the button
briefly to switch the alarm sound off.
Temperature Adjustment
The thermometer is calibrated before delivery in a climatic chamber. The temperature at the
installation site can differ from the living space temperature, due to structural conditions (outer wall,…).
Therefore, you can adjust the temperature display to the living space temperature.
1. Take a second thermometer and place it in the center of the room.
2. Wait a while and compare the two temperatures.
3. If the two measured temperatures differ greatly from one another, you can now change the
temperature display.
4. Wait or change (see: Display Alternation On/Off) to the temperature display.
5. Press the button H to lower the temperature display, or the button M to raise it. With each press of
the button H or M, the temperature display is lowered or raised by 0.5°C. This is signaled by a brief
sound. Since the temperature is displayed without decimal figures, the display only changes with
every second press of the button.
Note:
In order to restore the thermometer to the delivery condition, wait or change (see: Display
Alternation On/Off) to the temperature display. Press the button (H or M) in the opposite
direction. This means that if you have raised the temperature display (button M), repeatedly
press the button H until you hear a longer sound.
