Operator
’
s Manual
MO080-IT
12/09/2017
Rev.3
Page 12 of 20
6
Adjustments
6.1
Yearly inspections by operator
Keep to the yearly inspection schedules and inspect the product according to IEC 62353 standard.
6.2
Repairs
The Product must only be opened by technical assistance staff.
The only repair job with which the technical assistance personnel are charged is changing the fuses, as indicated in
paragraph 6.6. Any other special maintenance jobs must be done by the manufacturer.
CAUTION
: Interrupt the power supply before doing any maintenance jobs.
CAUTION
: Making any changes to this appliance is forbidden.
6.3
Adjustments
The Product is sold already balanced and does not require further adjustment. If the Product becomes unstable over
time and fails to remain in position, see section 10. If, after adjustment, the product still fails to remain in position,
contact the GIMA after-sales service.
6.4
Troubleshooting
N
o
.
Problem
Solution
1
The Product fails to work
Check the integrity of the fuses. If any one of the fuses is
damaged replace it as indicated in section 6.6.
If the product still does not work, contact the assistance service.
2
The Product does not remain in position
See par. 10. If, after adjustment, the product still fails to remain in
position, contact the GIMA after-sales service.
3
The light flickers
Contact the after sales service
4
The light beam is not focalised
Contact the after sales service
6.5
Routine maintenance
N
o
.
Period
Action
1
Once a year
Perform complete movements of all Product joints and make sure movement is smooth. If
the Product fails to maintain its position or its movements are hard, see par. 10.
2
Once a year
Make sure the bar retention screws are tightened properly. Also check the bar horizontal
arm retention screws.
If these are not properly fastened, adequately tighten. See drawing 190.
To access the screws, loosen the 3 dowels (1) of the ring (2). Remove the bar cover (3) by
pulling downwards . Tighten the 4 nuts (4), the screw (5) and the safety dowel (6). Make
sure the screws (7) of the horizontal arm are properly tightened.
3
Once a year
Check the condition of the Product paint. Make sure there are no paint pieces that could
fall in the patient area.
Содержание PRIMALED SO
