Page 2 of 3
www.gillathletics.com
800-637-3090
12/2/2021
730182 - FUSION 8x8 STARTING BLOCK
All rights reserved.
INST730182
Copyright
2021 by Gill Athletics.
INSTRUCTIONS
Rail
M8 x 16mm Flat Head Cap Screw
Handle
False Start Bracket
Rail
M8 x 16mm Flat Head Cap Screw
Pedal Plate
Pedal Pad
bottom of each pedal.
Fasten the handle to the front of the rail with the flat head
4. Handle
screw provided.
Slide each pedal onto the rail so that the pedal pad is facing
- Allen Key (provided)
1. Pedal pads
- Spike Wrench
- Needle Nose Pliers
The following tools are needed:
The FUSION starting block is shipped unassembled.
towards the open end of the rail.
to pull the tab off of the pedal pad.
2. False start bracket
Gently wiggle the tab to help it through the hole. Be careful not
gently pull the tabs through the holes with needle nose pliers.
Use one hand to press on the pedal pad. Use the other hand to
the false start bracket.
3. Pedals
Make sure that the "teeth" of the rail are pointing away from
Set the angle of the pedal to the 60 position.
Insert the tabs on the pedal pad into the holes in the pedal plate.
Fasten the false start bracket to the back of the rail with the
flat head screw provided.
Flip the starting block over and install the spikes into the
5. Spikes