FD 10
0549-990-01---10a_2019.11.indd
B
D
C
E
A
C
E
B
B
A
C
C
A
37 / 65
1,5
1,5
650
29 / 57
400
11
≈ 15°
D
E
25 Nm
0549-990/02a
Page 20 of 69
Mounting and operating instructions
2. Close the door leaf.
3. Screw down the rotating arm (D) on the drive unit
Tightening moment
25 Nm
.
Attention:
The pre-stressing of the rotating arm (D) depends on the existing lintel depth.
Example: Lintel depth 0 mm, pre-stressing of the rotating arm (D) ≈ 15° (1 grid increment of
the output shaft = 15°).
4. Slide the open position stop piece (B) into the sliding rail (C).
5. Slide the sliding rail (C) over the glider (E) and bolt it onto the door leaf.
6. Screw down the open position stop piece (B) approx. 5° before the door leaf reaches the
maximum open position.
7. Insert the covering caps (A) on both sides.
Attention:
Check the motional sequence of the door leaf: The rods must not touch!
If the glider (E) makes screeching noises, it needs to be lubricated wih a little WD40.
forward to chapter 4.7
