Gilera Runner 125, Руководство пользователя

Страница: 46 / 80

STOP. IF THE SEGMENTS KEEP FLASHING, CONTACT AN AUTHORISED
SERVICE CENTRE.
Recommended products
AGIP PERMANENT SPEZIAL
Ethylene glycol-based antifreeze fluid with organic inhibition additives. Red, ready to
use.
ASTM D 3306 - ASTM D 4656 - ASTM D 4985 - CUNA NC 956-16
03_17
03_18
Checking the brake oil level (03_17, 03_18, 03_19)
The brake fluid reservoirs are fitted with a transparent indicator « A »; the amount of
brake fluid seen through the transparent indicator shows the level of fluid contained
in the tank.
When the indicator « A » is full, the level inside the reservoir exceeds the MIN level;
when it is partially full, the level drops to the MIN level; when it is fully empty, the level
of fluid in the reservoir is below the MIN level.
The brake fluid level may fall due to wear on the brake pads. In case the pad wear is
below the minimum mark, contact an
Authorised Service Centre to have the braking
system thoroughly checked. If you need to top up the level, follow the steps listed
below. Remove the front handlebar cover, remove the two screws «
B », unscrew the
two screws « C », lift the brake liquid cover « D » and add as much fluid as necessary,
(the fluid level must always be above the minimum level mark). Place the handlebar
in the riding position and pay attention not to tilt the vehicle in order to keep the brake
fluid reservoir in horizontal position when checking the fluid level.
CAUTION
TOP-UPS SHOULD ONLY BE CARRIED OUT WITH DOT4 CLASSIFIED BRAKE
FLUID.
46
3 Maintenance