Gilbarco Advantage K35496, Руководство по введению

Страница: 7 / 10

Assembling the Panels [M00781B001 (Encore Units Only)]
MDE-2636D Canopy Kits (K35496 and K35498) for The Advantage® Series and Canopy Kit (K96632-02) for Encore® · September 2012 Page 7
Assembling the Panels [M00781B001 (Encore Units Only)]
The Assembling Panels (M00781B001) are as shown in Figure 2 .
Figure 2: Assembling the Panels (M00781B001)
Hex Bolt
(M01115B004)
Panels

(M00781B001)
Hex Nut

(M01114B004)
Flat Washer (M00959B010)
Lock Washer (M01020B001)
Flat Washer (M00959B010)
To assemble the four major panels (M00781B001), proceed as follows:
Note: Before assembling, check the panel graphics for proper positioning.
1
Position the end panel and side panel, so that the two holes in each corner are aligned.
Note: Use the truck bed as a work table and assemble by placing either the short panel flat
and installing the long panels from Figure 2 .
2
Place the Flat Washer (M00959B010) on the Hex Bolt (M01115B004), and then insert the

Hex Bolt (M01115B004) as shown Figure 2 through one of the two pairs of aligned holes in
both the panels.
Note: Use the needle nose pliers to hold the Hex Bolt (M01115B004) and Washer
(M00959B010).
3
Fasten and secure the Hex Bolt (M001115B004) by installing in the following order:
• Flat Washer (M00959B010)
• Lock Washer (M01020B001)
• Hex Nut (M01114B004)
4 Repeat for each of the two holes on all the four corners of the assembly.