MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019
Page 59
Passport Edge Software Setup
22
Once the tablet has been fully authorized, tap the
EDGE
icon and you should see the
following sign on screen.
Figure 84: Screen After Full Authorization
Configuring Passport Receipt Printer
To configure and setup the Passport Edge Receipt Printer, proceed as follows:
Note: Refer to
“Appendix A: Epson TM-M30 Programming”
if this method doesn’t
work.
Receipt printer(s) are configured to 10.5.61.52 before it leaves the factory. The following
steps are used to change that setting to 10.5.61.53, so that the printer can be used for a
second CWS.
IMPORTANT INFORMATION
Note: Before beginning the configuration, ensure that you have administrator right on the
laptop/PC that you will be using.
1
Power up the printer while holding down the “paper feed” button.
2
When the “blue light” flashes five times, release the “paper feed” button.
3
The Epson Ethernet
®
printer will print out the setup information (see
). If the printout
is different than the one shown in the example, then use one of the two methods found in
“Appendix A: Epson TM-M30 Programming”
to program the printer correctly.
Note: This is an example of the IP printout. Details may vary.
Figure 85: Printing the IP Address
