MDE-5440B Heater/Fan Kit (M14702K00X) Installation Guide for Encore® 900 Units · October 2021
Installing the Heater/Fan Kit for Encore 900
Page 7
Installing the Heater/Fan Kit for Encore 900
In the event of inclement weather, including snow, ice, or flooding that makes driving
conditions dangerous, please avoid servicing units. Always use available door stops to
secure upper doors against unwanted/unexpected movement, especially during high
winds. If necessary, reschedule service to avoid damage to the equipment. Weather may
change unexpectedly; be aware of local weather conditions. During service, if conditions
develop making service unsafe, close the unit(s) and proceed to a safe location.
WARNING
To install the Heater/Fan Kit, proceed as follows:
1
Remove and retain the lower panel.
2
Open the main door.
3
Position the heater so that the cables are on the Side A of the unit [the side with the Pump
Control Node (PCN)].
4
Place the heater on the section of the U-channel as shown in
.
Figure 1: Heater Mounting Location
U-channel
plate shot
